Cylinders 2 and 5 not firing on a 96 grand caravan
Asked by jvanburen Nov 14, 2011 at 08:34 PM about the 1996 Dodge Grand Caravan SE FWD
Question type: Maintenance & Repair
I am stumped. it just died on me one day. I replaced the coilpack, and it will start and run,
but only on 4 cylinders. I replaced the plugs, and wires. Still no change. I was thinking
maybe ecm, or camshaft position sensor, but cant afford to just keep throwing money at
it. Has anyone else experienced this problem?
6 Answers
junkyarddog135 answered 13 years ago
I would think that the coil you got is not any good if it had stop running, then after you replaced the coil it runs, but only on 4 cyl. I would bring that coil back and try another one. Could be the problem.
Thank you for responding. I should have mentioned that I did warranty the coil for another one, and had the same issue. Still stumped.
MrRocket12 answered 13 years ago
Hello. I once had the same problem on a VW Golf. It turned out to be bad ground connections on multiple points. Replaced two ground wires and the rest of the ground contacts i cleaned with contact cleaner and some sandpaper. That sorted my prob out. Hope it helps you
juventus53 answered 11 years ago
I had a similar problem and it turned out to be the oxygen sensors. They were faulty, telling the computer the wrong amount of gas to use so it misfired. Once replaced , it does not do it anymore.
Dodgegirl03 answered 7 years ago
Did you ever figure out why it was only firing on 4 cylinders I have the same problem in my 2003 dodge grand caravan
did anyone including dodgegirl03 figuer it out ? i got the same issue
