Which fuse? (tail lights)

do you have a fuse saying parking lights? because your problem is in the parking lights

Thanks! been working on it this morning, It isn't the fuse... I am about to basically rewire the whole deal, also tried a new switch as well.

do you mean the headlight switch? cause your parking lights do run through it.might have a short in it. but if you changed the brake light switch it won't have anything to do with it. good luck paul

Yeah, literally changed the headlight switch. Actually I have changed everything except the wiring harnesses. I just need to trace the route with a multimeter and find the problem.

I had a problem with one of my tail lights out on my 98 seirra. what i was told was where the bulbs plug into kind of a circiut board where all three bulbs are connected. you will need to replace this. they are like 20 dollars at autozone. took me 15 min.. problem solved

check ground connection its towards the rear of the truck, might be connected to tow connectors. bad ground. if not there are new tail light assembly

Solution: The driver's side rear tail light wires are exposed underneath and need to be wrapped with electrical tape. Solution: The tow light wires at times get cut or stretched and break from towing or from the tail gate, need to be wrapped with electric tape or removed if you don't want to use it anymore.

The dash lights, tail lights and front running lights on my 94 gmc were out. I wiggled the headlight switch and they came on. Never did find the fuse that fed the tail lights, etc. There is a hole in the fuse panel for DRL (daytime running lights) but there are no connectors to plug a fuse into. Where is the fuse for the tail lights?

my 94 gmc had no tails and brake lights would stop working when i put the tail lights on,,,found a tralier harness pluged into factory harness,,,unpluged,cleaned the frame and added new ground,,,.problem solved

The tail lights on my 94 GMC also quit working at the same time the instrument panel lights quit working. I replaced the wheel switch that dims the instrument panel and that also fixed the tail light problem.

Same problem on 2012 Sierra. No right side running lights. Turn sig works, brake lights up, new bulbs and good fuses. Found that all the wires run to a connector block behind the bumper, behind the spare. The connector simple came loose. Problem solved. Couldn't have done it without this sight! Thanks!!

My tail lights wint work but all the other lights work in my 1999 chevy silverado 1500 any suggestions

YOU HAVE A BAD GROUND...LOCATED ON LEFT FRAME RAIL/DRIVERS SIDE..NEAR THE LEFT REAR TIRE...CRAWL UNDER YOULL SEE IT...CLEAN SURFACE ON FRAME ADD NEW CONNECTOR..ALSO MAKE SURE YOU DONT HAVE A CRODED 3 WAY FOR TRAILER ..TOTAL COST 10 BUCKS TIME 10 MINUTES...PS YOU DONE YET'' LOL JOE BOSTON MA

Thanks bud you're a smart man I have a 98 Chevy pickup K 1500 the blinkers worked and the brake lights but no tail lights I cleaned up the ground connection and Bolt put it back together and boom tail lights again thank you

On a 1988 Chevy pickup truck which fuse in the fuse block works the tail lights

My 2001 Silverado the parking lamp fuse blew. Now no dash or tail lights. When I go to put in new fuse the circuit is hot (sparks) with the ignition off. Strange, I know. any thoughts?

dead short somewhere, look for a hot wire that is grounding to metal

I have a 1993 Chevy K 1500 I just recently change the fuel pump my tail lights worked fine before once we got done I fired it up Hotel lights no blinkers so we thought it was a fuse it changed out the fuse and now I only have tail lights when I press the brakes and the headlights are off but when the headlights are on the tail lights don’t work

2005 Silverado. Has 2 ta light fuses..under the hood.just to the left of parking lamp relay