How do you replace front wheel drive motor 3.4? I need to know how to take the motor out.
5

Asked by Kathy Nov 23, 2013 at 10:08 PM about the 1998 Pontiac Trans Sport 4 Dr Montana Passenger Van

Question type: Maintenance & Repair

I would like to replace both motor and transmission and would like to know how I would pull them out together.  This is a front wheel drive van.

2 Answers

migration_judge_roy answered 10 years ago

remove the hood, remove the engine mounts disconnect the drive axles, the radiator, fuel supply the ignition coil the control and sensor wires~ should pluck right up without anything being connected anymore~

3 people found this helpful.
Mark helpful
495

Jedidiah answered 10 years ago

Have done front wheel pulls a lot out the bottom of vehicle, but without a lift, not gonna happen for ya. Pop harness, mounts and hood, axles out of trans and pull from the right side of vehicle will be best bet. With lift, mounts, harness, axles, support from top and remove cradle assembly, motor and trans will stay on floor and then just lift body!

4 people found this helpful.
Mark helpful

Your Answer:

Related Questions

Trans Sport

Looking for a Used Trans Sport in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

Shortcuts

Search Pontiac Trans Sport Questions

CarGurus Experts

  • #1
    Wesley Beadle
    Reputation
    130
  • #2
    Gene Arnett
    Reputation
    110
  • #3
    tenspeed
    Reputation
    100
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.