TURN SIGNAL STOP WORKING AND WHEN i REPLACE FUSE IT BLOWS IMMEDIATE

Asked by NDMarkson1 Aug 30, 2018 at 03:25 PM about the 1998 Subaru Legacy L Sedan AWD

Question type: Maintenance & Repair

1998 SUBARU LEGACY SEDAN 2.2L TURN SIGNAL STOP WORKING AND
WHEN I REPLACE FUSE IT BLOWS IMMEDIATE, I HADE SHOP LOOK AND
THEY SAID IT WAS BACKUP SWITCH INTERNAL FAILURE. WHAT IS A
BACKUP SWITCH AND WERE IS IT LOCATED

GuruVQDWG answered 6 years ago

How do I turn off anti-theft device on my own car

1 people found this helpful.

Mark helpful

Your Answer:

TURN SIGNAL STOP WORKING AND WHEN i REPLACE FUSE IT BLOWS IMMEDIATE 1 Answer

1998 SUBARU LEGACY SEDAN 2.2L TURN SIGNAL STOP WORKING AND WHEN I REPLACE FUSE IT BLOWS IMMEDIATE, I HADE SHOP LOOK AND THEY SAID IT WAS BACKUP SWITCH INTERNAL FAILURE. WHAT IS A BACKUP SWITCH AND...

1998 Subaru Legacy L Sedan AWD

-

Maintenance & Repair
Rpm up an down when drive slowly or round about or tarific signal vehicle jhark h and stop 2 Answers

My car is rpm up and down when slow the car on round about or tarific signal vehicle jhark and stop and when engine run or idle position this problem was also come but engine is not stop or off

2005 Subaru Legacy 2.5 GT AWD

-

Maintenance & Repair
i have a 1997 subaru when i turn sharp truns it clicks and it wants to jump over it self ( like the old 4x4 trucks do when u turn in 4x4) only at low speeds it does it 5 Answers

i have a 1997 subaru legacy l sedan when i turn sharp truns it clicks and it wants to jump over it self ( like the old 4x4 trucks do when u turn in 4x4) only at low speeds it does it. i replaced all ...

1997 Subaru Legacy L Sedan AWD

-

Maintenance & Repair
Ilm fuse keeps blowing. 4 Answers

Hello. I am after a little advice if possible please. The ilm fuse keeps blowing on my car when i turn the side lights on. The side lights still all work but it stops the interior dashboard lights...

2007 Subaru Legacy 2.5i Wagon AWD

-

Maintenance & Repair
I turned my 97 Subaru legacy 2.5gt off. When I tried to restart it everything was dead!!! It was like the battery wasn't hooked up. I took the keys out and walked in the house. I looked outside and the tail light were on and the front amber lights were on. I tried to start it and nothing. I cleaned the battery posts but it didn't help. I unhooked the positive cable and put the key in the ignition and turned it on in order to hook the positive cable up. It started just fine, however the running lights are still on and the dash lights are blinking! I turned the engine off and the running lights were still on and the dash lights were still blinking. I had to unhook the positive cable to stop this process. Can anybody out there point me in the right direction??? 1 Answer

I turned my 97 Subaru legacy 2.5gt off. When I tried to restart it everything was dead!!! It was like the battery wasn't hooked up. I took the keys out and walked in the house. I looked outside and th...

1997 Subaru Legacy GT Sedan AWD

-

Maintenance & Repair

Used Subaru Impreza

25 Great Deals out of 476 listings starting at $3,850

Used Toyota Camry

52 Great Deals out of 985 listings starting at $2,212

Used Subaru Forester

28 Great Deals out of 1,075 listings starting at $2,695

Used Honda Accord

40 Great Deals out of 910 listings starting at $1,599

Used Honda Civic

180 Great Deals out of 3,705 listings starting at $1,995

Used Subaru WRX

21 Great Deals out of 517 listings starting at $8,990

Used Toyota Corolla

108 Great Deals out of 2,035 listings starting at $2,795

Used Honda CR-V

103 Great Deals out of 3,896 listings starting at $1,795

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

TURN SIGNAL STOP WORKING AND WHEN i REPLACE FUSE IT BLOWS IMMEDIATE

1 Answer

Your Answer:

Shortcuts

Search Subaru Legacy Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

TURN SIGNAL STOP WORKING AND WHEN i REPLACE FUSE IT BLOWS IMMEDIATE

1 Answer

Your Answer:

Related Questions