My subaru had a problem with power when i accelerate so i changed sparks plugs but still it has no power
no power,shaking of the engine
Asked by albertotiquejasse4 Nov 05, 2015 at 07:17 AM about the 2000 Subaru Legacy GT AWD
Question type: Maintenance & Repair
no power,shaking of the engine
TheSubaruGuruBoston answered 9 years ago
Try swapping out the MAF sensor, as it controls acceleration; an intermittent one with "bog" and prohibit smooth acceleration. Do you have a CEL? A PO301-4 would mean a wet, insufficiently pushed on, corroded, or shorting to ground ignition wire. Proceed and ask again as necessary.
no power,shaking of the engine
2000 Subaru Legacy GT AWD
-
Maintenance & Repair
Whines but will not start. I tried using either and still nothing. Can someone please help me. Coil pack good. Spark plugs good. Disconnected battery to try and reset the cpu. Please help.
1997 Subaru Legacy Brighton Wagon AWD
-
Maintenance & Repair
Battery is good but have no power in car
2016 Subaru Legacy 2.5i Limited AWD
-
Maintenance & Repair
Just bought the car and once I got it home I turned it off and it hasn't started since
1997 Subaru Legacy GT Sedan AWD
-
Maintenance & Repair
I turned my 97 Subaru legacy 2.5gt off. When I tried to restart it everything was dead!!! It was like the battery wasn't hooked up. I took the keys out and walked in the house. I looked outside and th...
1997 Subaru Legacy GT Sedan AWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.