Hornet_2497 answered 5 years ago
If it crunches and snaps more so on sharp turns, that would be the CV joints are worn out. You might also have the wheel bearings checked for looseness/wear on this older car, especially if the mileage is above say 150K. If all that checks out, then look at the struts....turn the wheel while it's up on the hoist checking wheel bearings.
I have occasional crunching or popping noise coming from the front end with my Avalon do I replace CV boots or struts any suggestions maybe an upgrade to a better suspension?
2002 Toyota Avalon XLS
-
Maintenance & Repair
Or so it seems. When my 2008 Avalon is cold, and I first drive off, there is a clicking / grinding sound that seems to come from the left front corner. Much like if the CV joint was bad? The car ha...
2008 Toyota Avalon Touring
-
Maintenance & Repair
I replaced the struts on my car and now the front end sits lower than it did, how do I raise it up?
2001 Toyota Avalon XL
-
Maintenance & Repair
I have a 2005 Toyota Avalon, with 74,000 miles and has never been in an accident. I was experiencing extreme shaking and vibrating while braking. Found that the calipers were frozen. I had the calip...
2005 Toyota Avalon Touring
-
Maintenance & Repair
When I goose the Avalon the front end gets loose and effectively Fishtales. It is certified as new. A different Toyota dealer says it is the torque and they could find nothing wrong with the front ...
2011 Toyota Avalon Base
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.