how do i remove and install an ignition switch on a 1993 toyota 4x4 pick-up truck?
need to change ignition switch, key goes in, won't turn unless i jiggle it. would be helpful if you could include pictures or images along with step by step instructions, thank you.
Hi Olabals, I couldn't find anything specific to the 93 Toyota ignition switch but I did find general information on how to remove and replace the ignition switch. http://www.autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/05/00/ee/0900823d800500ee.jsp
Its very easy my friend. First, remove the lower dashboard panel in order to get at the switch. There are four philips screws and one bolt that secures this panel. Then remove the two nuts and three bolts securing the steering column to the dash frame. This makes it easy to get at the switch. Remove the cover around the ignition switch. The front part is the key and lock tumbler, and the bottom is the electrical switch part that is not disturbed by this process. Take care not to pull the wires in the wire harness to the switch. Remove the key sensor switch from the housing that holds the tumbler and switch mechanism. Remove the screw that holds the ignition switch body. Remove the electrical harness part from the back of the switch. Then, insert the key and turn slightly. Release the pin under the tumbler casing and pull out the cylinder. Marina Del Rey Toyota
can this be done if the key wown't turn in the ignition?
Please check these links you can find here best solution related to your query.... http://www.ehow.com/how_7943588_do-1998-honda-shadow-750.html http://www.ehow.com/how_7975627_do-switch-1975-mg-midget.html How to build homemade generator
Thinking of Prius for long time…I just walked [url=http://www.toyotaplace.com/]orange county Toyota[/url] dealer and bought it. It was a hastened decision, but it’s like that….simply I was impressed by their service. so I recommend it you contact the Toyota dealer Hope they can give you best suggestion for your V6 4WD…
Thinking of Prius for long time…I just walked [url=http://www.toyotaplace.com/] orange county Toyota [/url] dealer and bought it. It was a hastened decision, but it’s like that….simply I was impressed by their service. so I recommend it you contact the Toyota dealer Hope they can give you best suggestion for your V6 4WD…
1993 Toyota 4 cylinder pickup; Engine starts normally, but only runs for about 3 to 5 seconds then dies. Have replaced the following; fuel pump, fuel filter, fuel pressure regulator valve, cold start injector, distributor cap and rotor, spark plug wires, spark plugs, signal generator, and coil. Have resistance tested the start injector timing switch and the cold start injector, they are spot on. After attempting to start the engine 10 to 12 times, the engine starts and runs flawlessly. There is no missing , lagging, or hesitation at any speeds including stops and starts. However when the engine is shut off the starting problem begins all over again. Any suggestions?
rwaters42@hotmail.com
Sounds like my moms truck she took to shops all over and dealer changed everything you have done some result..my Cuz came down to visit told me to pop the hood it was the distributor pick up...7.00 dollar part ......lol
My truck is doing the exact same thing.the diagnostic code says its the ignighter but I have put 3 different ones on it,all brand new and it doesn't help.I've donw everything the other guy has to no avail.I'm going to try a new ignition switch next.any other suggestions?
