How to reset check engine light after replacing bad fuel pressure sensor?
How to reset check engine light after replacing bad fuel pressure sensor?
Asked by radish1862 Jun 13, 2018 at 04:59 PM about the 2003 Chevrolet Impala FWD
Question type: Maintenance & Repair
How to reset check engine light after replacing bad fuel pressure sensor?
How to reset check engine light after replacing bad fuel pressure sensor?
2003 Chevrolet Impala FWD
-
Maintenance & Repair
I replaced the crankshaft pulley on my 2000 Impala. Now I need to reset the check engine light. How do I reset it?
2000 Chevrolet Impala FWD
-
Maintenance & Repair
Check Engine light keeps coming on, code states gas cap, replaced gas cap but twenty minutes after it was reset at the garage it came on again, code states same issue. How can I reset the Check Engi...
2008 Chevrolet Impala
-
Maintenance & Repair
I have plenty of fuel..n car keep idling low...n then cut off..had Auto zone read codes off computer P0401 Insufficient EGR flow detected.. What's wrong with my car??
2004 Chevrolet Impala LS FWD
-
Maintenance & Repair
The service engine light came on. Went to Auto zone and the codes came up gas purge canister code and I had it repaired. The light did not go off. New code reading was secondary air injection code. Th...
2009 Chevrolet Impala 1LT FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.