I can hear window motor running but doesn't move would at first with a little help.
After removing door panel and speaker to look inside door I seen a lot of
rust on the large gear. WITHOUT power on I tried to move it manually.No
Good. I ended up drilling rivet out to remove gear and motor to test, When I
did this I felt the long gear break loose a little. I tested the motor by itself it
was working fine. I sprayed the the gears and the guide for the window with
the dollar general version og WD40 and worked it up and down by hand
until it moved freely. Just a note I wasn't sure what to back in first but riveted
the arm first then motor. Window still doesn't operate properly. Is there
another adjustment that I don't see.