Possible cause?
Replaced, cap rotor, both crank and
cam sensors, truck would try to start
after key went back to run position.
Asked by Fordrebuilder Nov 28, 2016 at 05:42 PM about the 1998 Dodge RAM 1500 Laramie SLT Club Cab LB 4WD
Question type: Maintenance & Repair
Replaced, cap rotor, both crank and
cam sensors, truck would try to start
after key went back to run position.
Replaced, cap rotor, both crank and cam sensors, truck would try to start after key went back to run position.
1998 Dodge RAM 1500 Laramie SLT Club Cab LB 4WD
-
Maintenance & Repair
Wanted to know if it what cause it
2005 Dodge RAM 1500 SLT Quad Cab 4WD
-
Maintenance & Repair
whenever I crank the truck it will start back firing and popping then goes dead, what will be the cause of this happening
1997 Dodge RAM 1500 LT RWD
-
Maintenance & Repair
I have an 01 dodge ram and recently the engine will heat up to close to 210 degree even when going 80 on the interstate. What could cause the problem?
2001 Dodge RAM 1500 SLT Plus Quad Cab LB RWD
-
Maintenance & Repair
The plugs for the 4.7 have a reach of 3/4". I believe my mechanic may have installed the plugs for the 5.7 hemi which are 1" in reach. My truck went into the shop perfectly fine and came out with th...
2007 Dodge RAM 1500 SLT RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.