How hard is it to put a 95 and below Cummings standard in a 01 automatic half ton just swap have everything I need just looking at difficulty and special tips?

How hard is it to put a 95 and below Cummings standard in a 01 automatic half ton just swap have everything I need just looking at difficulty and special tips? 1 Answer

Can I take a 98 trans and put a stander transmission in it 1 Answer

I had it rebuilt and it doesn't have the power it Had before and now it's acting like it's sliping so I whanted to just put a standard in it

I have a 2005 dodge ram hemi 1500 5.7 liter. It is all stock. I want to make it sound louder and good time. Should I dual it with a flowmaster muffler or just put flowmaster on stock single exhaust 1 Answer

What size of inlet outlet would I need?

Is it ok to swap a 46rh to a 46re? 2 Answers

I have 97 dogde ram 1500 reg cab 2x4 5.9l, the tranny that it has i believe it is the 46rh( my transmission has the OD end pointy) but it is going bad its stuck on third gear. I found some one s...

I was putting a new radio into my 03 Ram 1500 and just to make sure the radio worked in it.I must have not protected a couple of the wires all the way and a couple of the wires touched on the back of the radio. after the fact, the courtesy light wont come on when opening the door, and Pretty much all the functions that a vehicle is supposed to perform without turning on the vehicle don't work. and neither does the radio when I hook it up. Yes, i checked all the fuses in my fuse box. I even wen to the point of replacing all of the, even the ones that i thought had nothing to do with the situation. the radio still works because i checked it by putting power to it by directly putting it to the battery. and the fuse didn't pop in the back of the radio when all this happened. so at this point I'm completely lost. Any help with this would be much appreciated. 1 Answer

Putting in a new radio, a hot touched something and now nothing works.