i bought a used 1500 2 wd it had been in a shop for transmission work i dont know if it was rebuilt or replaced but no od i changed the netural switch and still no od

i bought a used 1500 2 wd it had been in a shop for transmission work i dont know if it was rebuilt or replaced but no od i changed the netural switch and still no od 1 Answer

i have a 99 dodge ram 1500 and just had the transmission rebuilt and it still wont shift out of 2nd gear....what else could it be?? 2 Answers

I just bought a 99 dodge 1500 a few months ago and just had the tranny rebuilt and it still wont shift out of second gear..what else could it be..we replaced all the sensors and rebuilt the vavle bo...

I have a 1998 Dodge ram 1500 just rebuilt the transmission and put it back in the truck. now the truck will turn over but will not start. 1 Answer

i replaced the cam shaft postion senor that did not work.. i am not getting spark but i am getting fuel and compression. i tested the battery it is still good..you can still hear the fuel pump kick on...

I have a 2002 Dodge Ram 1500 4x4 4.7 Sport. I recently put in a new/used motor because my old one had a bad crankshaft. So after getting new motor in I started the truck and it ran great. I only ran it for about 5 seconds because I noticed I had a broken transmission line. I went back the next day and fixed the line. I went to start the truck back up and nothing happened. No click no nothing, everything lights up on dash. My engine light comes on and blinks about tens times than stays steady. My gear selections are all lit up. Does anyone know the do it yourself solution? 1 Answer

I have a 2002 Dodge Ram 1500 4x4 4.7 Sport. I recently put in a new/used motor because my old one had a bad crankshaft. So after many hours of getting new motor in, I started the truck and it ran gr...

My 94 dodge ram 1500, 5.2L, runs okay but began using lot of fuel. Had trouble codes 37, 32, and 51. Cleaned throttle body and checked for vaccum leaks or bad hoses. Code 32 gone away. Cleared code 51 which according to Haynes manual is not supposed to make the check engine light come on. Their is no code 37 in the Haynes manual for a gasoline engine on the 94 Ram. Their is for diesel engine. What is it, where is it at and how do I correct the problem. 51 I know is the O2 sensor. Truck runs great, shifts fine , but is still using more fuel than normal. Been reading about code 37 and transmissions, don't think my problem is there. Any help ? 5 Answers

Cannot get the Code 37 to clear, can disconnect the battery and the code 51 clears, The code 32 has not come back but 51 comes back. 37 does not go away. Engine light will not come on after starting...