Camshaft Sensor Removal
I've removed the camshaft sensor. How do I disconnect the electrical plug? Is there two catches holding it on...one on each side? Do I lift these with a small flat-head screwdriver?
Asked by JamesL May 12, 2007 at 07:52 PM about the 2003 Dodge RAM 1500 SLT Quad Cab LB RWD
Question type: Maintenance & Repair
I've removed the camshaft sensor. How do I disconnect the electrical plug? Is there two catches holding it on...one on each side? Do I lift these with a small flat-head screwdriver?
I've removed the camshaft sensor. How do I disconnect the electrical plug? Is there two catches holding it on...one on each side? Do I lift these with a small flat-head screwdriver?
2003 Dodge RAM 1500 SLT Quad Cab LB RWD
-
Maintenance & Repair
2003 dodge ram 1500 V8 4.7 Stalls in the middle of driving at random times, the truck will run fine for a few days sometimes weeks and then it will just stall oit of nowwhere. Hooked a computer up...
2003 Dodge RAM 1500 SLT LB 4WD
-
Maintenance & Repair
Ok so I have a 97 dodge 1500 4x4 just changed the clutch and I broke the camshaft sensor so I replaced it but now it keeps blowing my engine fuse also I stuck a 60 amp fuse in it and ran fine what...
1997 Dodge RAM 1500 Laramie SLT 4WD
-
Maintenance & Repair
how do you change the camshaft position sensor
1997 Dodge RAM 1500 SS/T RWD
-
Maintenance & Repair
i put new camshaft sensor, new crankshaft sensor, new rotary cap, new rotary cap button, new coil, and fuel pump wont start
1997 Dodge RAM 1500 Laramie SLT Club Cab LB 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.