Asked by Joshua Jun 08, 2020 at 04:01 PM about the 2003 Dodge RAM 1500 SLT 4WD
Question type: Maintenance & Repair
My 2003 dodge ram 1500 4.7 ltr v8 is hard to start
and once started will stall when the accelerator
pedal is depressed. I have recently installed a new
fuel pump. Have also changed ignition switch,
crankshaft sensor, and camshaft sensor. Not sure
where to go next.
beatupchevy answered 4 years ago
If you're replacing parts on a whim without testing anything then take it to a mechanic , you could have bought a scanner , multi tester with the money you spent on parts you didn't need ,
Inside your tipm there is a fuel relay that probably your problem happens a lot on Dodge products
My 2003 dodge ram 1500 4.7 ltr v8 is hard to start and once started will stall when the accelerator pedal is depressed. I have recently installed a new fuel pump. Have also changed ignition switch,...
2003 Dodge RAM 1500 SLT 4WD
-
Maintenance & Repair
my horn dont work
Dodge RAM 1500
-
Maintenance & Repair
Searched for: I have 97 dodge ram 1500 my right rear turn signal is not as bright when flashing but at the same time the back up lights flash faintly. How do i fix this?
1997 Dodge RAM 1500 Laramie SLT 4WD
-
Maintenance & Repair
The four x four went out of my doge truck. It works in two wheel drive. How can I fix it?
1996 Dodge RAM 1500
-
Maintenance & Repair
I have a 1996 dodge ram and every time I go to start it it won't turn over and the fuse for my dash blows every time I put a new one in it how can I stop that from happening?
1996 Dodge RAM 1500 LT LB 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.