no there is a check engine light on but the code reads a slim or skim key code and i have no idea what that means.
I don't know what that might mean but I think you have a problem with the drive by wire system.
Mikes_auto answered 4 years ago
I tried to reset the oil lite that will not reset but I was thinking that with it being on that could cause loss of power to the throttle cannot give it any gas has anyone had this problem it is a 2013 dodge ram hemie 5.7
when i went to put my truck in gear i have absouletly no throttle why is that? no power at all to drive it
2006 Dodge RAM 2500 SLT Mega Cab RWD
-
Maintenance & Repair
Loss of power after warm up. Sounds like engine gasping for air...definitely stops combustion at twenty percent throttle. No clogged Cat. New plugs. New air filter. Injectors clean. New TPS...MAP...
1994 Dodge RAM 2500 Laramie SLT LB RWD
-
Maintenance & Repair
2001 Dodge Ram only runs when gas is poured down throttle body. Changed crankshaft position sensor, camshaft position sensor, coil and wires. Put in a rebuilt ECM. Checked and found 50 psi at fuel r...
2001 Dodge RAM 2500 ST LB 4WD
-
Maintenance & Repair
My diesel truck under heavy throttle acts like it is choking, I have an efi tune and a 5 inch exhaust. Just recently started doing this.
2009 Dodge RAM 2500 Laramie Quad Cab LB 4WD
-
General
2003 Dodge RAM 2500
-
Maintenance & Repair
CarGurus has 16 nationwide RAM 2500 listings starting at $7,900.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.