What might be causing No Power under load
It idles fine, and I can rev the engine in park and just a slight hesitation. But when in drive under load, it cannot accelerate smoothly. If you don't have to go up a hill, you can slowly get the RPM's up high enough to go.
So here is what I have done.
- Looked for any cracked/broken vacuum lines.
- Removed the catalytic converter. Ran without the converter up the road, still had little acceleration. Checked for blockage, none. Put the converter back on.
- Changed the fuel filter.
- Changed the front 3 spark plugs, worn - large gap.
- Changed the front 3 plug wires.
- Changed the distributor cap. (contacts were corroded).
- Checked the Air Flow meter, readings seemed to be fine.
- Checked the Throttle Position Sensor, seemed fine. Changed it with a new one (frustration), it did not help.
- Removed vacuum line from the EGR value, did not see any difference.
Ordered a gasket so I can take the air intake off, to get to the back 3 plugs and wires.
NOW - I just tried it and it ran fine, until it warmed up (just a mile or 2).
Grateful, thank you in advance for your time and help