You want to check the spark plug, cap, rotor, coil, and wires. If it's only one cylinder misfiring you likely do not have an issue with the ignition module. Not likely to be the coil either, or you would see misfires on other cylinders. I would start at plug and work your way back to cap & rotor.
1999 Chevrolet Suburban K1500 LS 4WD
-
Maintenance & Repair
My truck did not pass NH state inspection emissions test because: bank 1, sensor 1- O2 sensor #5 cylinder check engine light was also burnt out I replaced all 8 spark plugs, both front O2 sensors,...
1999 Chevrolet Suburban K1500 LT 4WD
-
Maintenance & Repair
How long does it take to change the front shocks and upper arm on a 1999 suburban 4x4 per the labor manual?
1999 Chevrolet Suburban K2500 LT 4WD
-
Maintenance & Repair
my 99 chevy suburban 5.7 350 is jerking or bumping when i reach speeds above 45 mph like it is shifting out of gear ive replace everything on this truck engine,transmission,destribito... and to much...
1999 Chevrolet Suburban K1500 LS 4WD
-
Maintenance & Repair
I have a 99 chevy suburban. I am having a problem with the oil pressure gauge. When I push the gas and let off as to coast for a bit the oil pressure gauge drops completely and the check gauges li...
1999 Chevrolet Suburban K1500 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.