I replace clutch and clutch cabel cause the clutch went out... I installed it... Before i fixed it i was abel to turn on the pickup in gear with clutch released and trun on eith peddle th to floor...

Asked by John Dec 29, 2014 at 07:54 AM about the 1990 Mitsubishi Mighty Max 2 Dr One Ton Mighty Max Standard Cab LB

Question type: Maintenance & Repair

Was able to drive around and shift
correctly... After i replace cabel and
clutch truck turn in same way but this
time i wouldnt shift in any gear... If
pick up was off it would shiftat all..

John answered 9 years ago

Can some give me an anwseru realky need help....

Mark helpful

20

Terrygreer75 answered 6 years ago

Clutch cable broke one day replace cable then it wouldn't never go into gear then placed transmission and clutch still did the same. When the transition is down you can push the lever all the way down but when you put the transmission up there you can't push it all the way down

2 people found this helpful.

Mark helpful

Your Answer:

I replace clutch and clutch cabel cause the clutch went out... I installed it... Before i fixed it i was abel to turn on the pickup in gear with clutch released and trun on eith peddle th to floor... 2 Answers

Was able to drive around and shift correctly... After i replace cabel and clutch truck turn in same way but this time i wouldnt shift in any gear... If pick up was off it would shiftat all..

1990 Mitsubishi Mighty Max 2 Dr One Ton Mighty Max Standard Cab LB

-

Maintenance & Repair
Where is the fuel filter located on a 1991 mitsubishi mighty max and how do i replace it? 2 Answers

My truck ran out of gas a few weeks ago now it starts up just fine but after I drive to the store or anywhere when I go to start my truck to go home it feels like it misfires and sounds like it backfi...

1991 Mitsubishi Mighty Max 2 Dr STD Standard Cab SB

-

Maintenance & Repair
How do i find out what's causing my truck to run very sluggish ?It won't pick up any speed.Even when i floor the gas it goes slower. 1 Answer

It's like something is stopping the gas,As soon as i start it up it's like it's idle is high or im pressing on the gas when im not

1991 Mitsubishi Mighty Max 2 Dr One Ton Mighty Max Standard Cab LB

-

Maintenance & Repair
sometimes i turn the key and nothing happens. no clicking, nothing. always starts using compression. any guesses 2 Answers

it will start fine most of the time. them I go to turn the key and nothing happens. If I wait a couple of minutes it might start. Sometimes it starts right away. I try an park on a slope whenever ...

1990 Mitsubishi Mighty Max 2 Dr STD Standard Cab SB

-

Maintenance & Repair
My 1988 Mitsubishi mighy max is acting its missing. Hesitates bad. And the radio flickers on and off. 10 Answers

I have changed the spark plug wires and the ignition coil. And cleaned all connections.dont know where to go from here.

1988 Mitsubishi Mighty Max 2dr One Ton Standard Cab LB

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.