AIT sensor problem
hello. long story short, and hope this is not a ecm,pcm, problem,no power at all getting
to the AIT sensor. out of the pig tail or after it as well from the 2 wires,red/with black
stripe should be 5v low ref from the pcm, with the tan wire carries the signal back. my
question, is their in any way ,shape ,form, a fuse that inter acts with this ? i dont think
so but never hurts to ask? heard sometimes the pcm goes bad on that side and hope
that is not the case ? by the way my code is PO113 and i know its a circut high
impute, being that the sensor has absolutely no power getting to it.. what do u think ?
pin test at the ecm ? thank u chris s