you have a sensor going bad and it needs to be replaced. I would recommend that you take it to a mechanc and get him to scan it, instead of just replacing sensors. it could be a loose connection. A scanner will point the mechanic in the direction of what is wrong
the code was PO102 MAF or VaF circuit low
1997 Chevrolet Malibu LS Sedan FWD
-
Maintenance & Repair
When driving it will jerk a few times. The engine light is off so not sure what it is
2014 Chevrolet Malibu LS FWD
-
Maintenance & Repair
My car needed to be jumped to start then when i came out of work it started but the engine light and traction light were on. There was no real power when I stepped on the gas peddal . I did drive it...
2010 Chevrolet Malibu 1LT FWD
-
Maintenance & Repair
i was trying to find the reason of too much fuel consumption, so that i tried first thing to clean the throttle body. but it jerks at idle.
2013 Chevrolet Malibu LTZ 1LZ FWD
-
Maintenance & Repair
My car will crank over but wont start. We replaced the crank shaft sensor, we checked to make sure there was gas going to the engine, fuel pump kicks on. There were three other codes on the check...
2004 Chevrolet Malibu FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.