How to replace the front brakes on my 2001 gmc z71 searrla and also my srvice 4wheel drive lit is on wont ingaudge or it sounds like its grinding

How to replace the front brakes on my 2001 gmc z71 searrla and also my srvice 4wheel drive lit is on wont ingaudge or it sounds like its grinding 1 Answer

How much would it be to rebuild or replace my 5.3l V8 engine on my 2005 GMC Serria that has 306,xxx miles on it??? 1 Answer

My truck has 306,xxx but I believe it can last a little bit longer. I have another vehicle but I would like my truck to go riding around in the mountains. I am just wondering if it would better to ...

Just replaced fuel pump on my 1998 GMC chevy cierra z71 4wheel drive truck.. I seemed fine and I drove I a couple days then it quit running. It's getting gas in pump but not presure. What can I do? 1 Answer

Also replaced relay fuse. Help

my 95 z71 gmc 4x4 350 tbi runs great half the time but sometimes when warm it skips and cuts out like its flooded. when shut off or stalls it wont start unles gas is held to floor and once it starts i 4 Answers

i have to hold gas to floor to keep it running it eventually clears out blowing smoke and will run

04 gmc sierra 1500 5.3 died on me on the highway got it towed home starting going at it, hooked two different scanners to it and not throwing any codes (ecm is working bc the map was reading correctly but also the rpm was zero) anyways checked fire none checked injectors they wasnt working either(built fuel pressure then unplugged fuel relay then turned engine over and the pressure stayed the exact same) i assume it might be the crank sensor but i would think it would throw a code, anyways came back this morning and before doing anything for the hell of it i checked the gas cap and tightened it and it fired up perfect three different times and the last time i let it run and it died after bout 45 seconds (fuel pressure reads 55) and after it died its doing the same thing cranks but wont fire or start 1 Answer

died on me on the highway got it towed home starting going at it, hooked two different scanners to it and not throwing any codes (ecm is working bc the map was reading correctly but also the rpm was...