Have a 1996 chevy lumana and if I go out and drive it then stop it won't start for 10 to 15 min then it will run like a dream any ideas I replaced the throttle position sencer no help

Have a 1996 chevy lumana and if I go out and drive it then stop it won't start for 10 to 15 min then it will run like a dream any ideas I replaced the throttle position sencer no help 4 Answers

I have a '99 Chevy Lumina LTZ, and for the first couple of years that I had it it would never really heat up until the past two years, when I noticed the temperature gauge actually moving. Anyway, when it heats up(needle in the center or right in the gauge), my car shakes and it shifts really hard. Any ideas? It has 172,xxx on it, and I'd like to get another year or so out of it without replacing anything major. 2 Answers

I have a '99 Chevy Lumina LTZ, when it heats up(needle in the center or right in the gauge), my car shakes and it shifts really hard. Any ideas? It has 172,xxx on it, and I'd like to get another y...

Car runs fine until you come to a stop and then if you sit too long it will die but it doesn't happen all the time. Just replaced the fuel filter have checked injectors Please help. 2 Answers

1990 chevy euro lumina 3.1 v6

Why will my 93 lumina v6 keep on dying when I go to stop and then when I try to go up hill it keeps sputtering like it ain't getting no gas? 1 Answer

Also it didn't start doing that until I started running the heat and when I turn the heat off it seems to run better

Chevy Lumina 91 3.1 4dr...multi...I got a codes, 14 and 42...14 is heat temp high...and 42 is a ESC or EST Eletric Spark Timing, now I went and got a paper clip to pull these codes...it works. 12,12,12, and 14,14,14 and then 4..2 so it is 42...42 is behind the coil pack and then also it is connected to the crank sensor...What ever it is...I did check spark on the to top right side coil pack and the spark is powerful...removing 2 plug wires to test spark...so under that, change that and then the crank sensor...and the the Heat sensor for the water or radiator 14 code. Any other helps is good...Thanks! 7 Answers

before it stalls engine light comes on all the time before it stalls...Code 42 and code 14 is what I got...I am going to change the crank sensor in the morning to see if this helps...but I am welco...