My cranckshaft pully fell off (well the threaded part did)

Asked by Anthony Jan 06, 2014 at 06:38 PM about the 1996 Chevrolet Lumina LS Sedan FWD

Question type: Maintenance & Repair

the rest is in tact and still on the car. I have a 96 chevy lumina. What all do I need to fix
this problem? Im a rookie at this stuff.

445

jimijobo answered 10 years ago

Not sure what failed exactly, but I'm assuming you need to replace the whole pulley, and you would need specialized tools (crankshaft pulley remover, cs pulley installer). Not a hard repair otherwise, low labor cost, probably you just have this done.

Mark helpful

Your Answer:

My cranckshaft pully fell off (well the threaded part did) 1 Answer

the rest is in tact and still on the car. I have a 96 chevy lumina. What all do I need to fix this problem? Im a rookie at this stuff.

1996 Chevrolet Lumina LS Sedan FWD

-

Maintenance & Repair
I have a 1995 chevy lumina and is leaking coolant engine over heats and shuts off it seems tht the coolant is leaking from the radiator any ideas of what my problem might be and how to fix 2 Answers

Car will start after cool down but once i shift into drive car will shut off... temp Gage goes down wen car starts but goes right back up

1995 Chevrolet Lumina Sedan FWD

-

Maintenance & Repair
Identify broken part 4 Answers

While putting in oil I found a broken part. Can you help identify? Connects to air intake and front corner of block.... the long tube

1991 Chevrolet Lumina

-

Maintenance & Repair
I have a '99 Chevy Lumina LTZ, and for the first couple of years that I had it it would never really heat up until the past two years, when I noticed the temperature gauge actually moving. Anyway, when it heats up(needle in the center or right in the gauge), my car shakes and it shifts really hard. Any ideas? It has 172,xxx on it, and I'd like to get another year or so out of it without replacing anything major. 2 Answers

I have a '99 Chevy Lumina LTZ, when it heats up(needle in the center or right in the gauge), my car shakes and it shifts really hard. Any ideas? It has 172,xxx on it, and I'd like to get another y...

1999 Chevrolet Lumina LTZ Sedan FWD

-

Maintenance & Repair
I have a vibration noise coming from the passenger side on my 1992 chevy lumina van. It did it for a brief couple seconds when turning right and than stopped and than about fifteen minutes later 2 Answers

and again at a stop light going about 15mph, the first time going around the corner I was only going about 20. It sounded like when you hit the ribbets on the side of the highway to let you know you ...

1992 Chevrolet Lumina

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.