My 1995chey blazer cranks but will not start. Once I jump it it will start.I replaced the crank sensor but that didn't help and I have a new batter . I really have no clue. Please help

My 1995chey blazer cranks but will not start. Once I jump it it will start.I replaced the crank sensor but that didn't help and I have a new batter . I really have no clue. Please help 1 Answer

Hey Gurus, I need your help. My 95 blazer cranks but doesn't start unless I spray carb cleaner into it then it will start and run fine all day. Next day I will have to spray it again in order to start it. Any tips would be appriceated. It has a 4.3 vortex auto and 4wheel drive. Thanks for your help. 2 Answers

Cranks but no start unless I spray carb cleaner into it.

1996 Chevy Blazer LS 4 door 4.3L vortec engine we were driving down the road and it was working good. Then I hear something pop in the front end. Right after that it got real rough skipping till we stoped at a light and it shut off. It will turnover but will not crank. We have changed the fuel pump sensor. Also the ignition control module has been changed 2 Answers

SUV was driving it and I heard a pop sound in the front some where. it started to skip really bad and shut off and has not cranked since, We have changed the fuel pump module or whatever it is calle...

I have a 1999 Chevy Blazer, 4x4, 4.3 vortec. We have changed the coil pack, fuel filter, distributor cap and button, the crank shaft sensor, cam sensor and plug wires as well as the ignition control module. We coming to a stop sign it will stall and sometimes when just sitting still. Sometimes it will start right back up and other times it takes several tries. I also have the oxygen sensor on order and it should be here tomorrow. Fuel pressure tested perfectly. No black smoke, no smell of rotten eggs or the cat glowing red. The only code that comes up is PO420. 4 Answers

I have a 1999 Chevy Blazer, 4x4, 4.3 vortec. We have changed the coil pack, fuel filter, distributor cap and button, the crank shaft sensor, cam sensor and plug wires as well as the ignition control m...

I need help with my 1990 k5 blazer 5.7 350 it's will start up run ruff and have to pump the gas when idling then about 4 mins later it starts to idle higher and higher then dies 1 Answer

I need help with my 1990 k5 blazer 5.7 350 it's will start up run ruff and have to pump the gas when idling then about 4 mins later it starts to idle higher and higher then dies so I try and start ...