The headlight low beams work, but the high beams don't, even after replacing the switch behind the steering whee...why, and what do I need to do to fix this problem?

Asked by GuruTM3JN Jul 22, 2018 at 05:50 PM about the 2002 Saturn S-Series 3 Dr SC2 Coupe

Question type: Maintenance & Repair

The headlight lowballs work, but the high beams don't, even after replacing the
switch behind the steering wheel....why, and what do I need to do to fix this
problem?

34,720

charles answered 6 years ago

Start checking grounds.

Mark helpful

DYI60 answered 5 years ago

On the 2002 L300, there is a relay module mounted in front of the battery. Inside is a circuit board with relays, diodes, etc. GM still carries this part and it called a fan relay module. However, if you trace the leads, they go to the headlights, marker lights and turn signal lights. It costs about $200 and unfortunately, the components are soldered into the board so the entire module must be replaced.

Mark helpful

Your Answer:

The headlight low beams work, but the high beams don't, even after replacing the switch behind the steering whee...why, and what do I need to do to fix this problem? 2 Answers

The headlight lowballs work, but the high beams don't, even after replacing the switch behind the steering wheel....why, and what do I need to do to fix this problem?

2002 Saturn S-Series 3 Dr SC2 Coupe

-

Maintenance & Repair
High Beams work only but low beams do not , both are out at the same time, why?? 2 Answers

At night when I put on my low beams they are out but when I go to high beams they are the only ones that work why? is there a fuse for the low beams or do both low beams bulbs need to be replaced??

1994 Saturn S-Series 2 Dr SC1 Coupe

-

Maintenance & Repair
I have a Saturn 1992 SL Sedan with 164,000 miles. I am having a major problem with the car cutting off while I am driving at a fairly constant speed or when I am idling at a stop light. The engine will shut off, along with the power steering and all other electronics. This happens when at a stop light only after I press on the gas to accelerate from a dead stop, but I am able to put the car in neutral and start the car again (sometimes it takes a while to restart). We tried getting the electronic control module repaired, but this did not fix the problem. We checked the oil and it appears to be of the correct viscosity for the engine. We are at our ends as to what needs to be done to fix this dire problem. Thank you for your time! 8 Answers

I have a Saturn 1992 SL Sedan with 164,000 miles. I am having a major problem with the car cutting off while I am driving at a fairly constant speed or when I am idling at a stop light. The engine w...

1992 Saturn S-Series 4 Dr SL Sedan

-

Maintenance & Repair
What can i do to test to see if my idling problem is the MAP Sensor or something else 3 Answers

I have a 2000 Saturn with a 1.9 litre engine that was running fine! Now my idle fluctuates dramatically and the gas mileage is terrible! What can I do to check the MAP Sensor or troubleshoot the probl...

2000 Saturn S-Series 4 Dr SL1 Sedan

-

Maintenance & Repair
Low beams with high beams 1 Answer

Switch from low beams to high beams the low beams go out

2002 Saturn S-Series 4 Dr SL Sedan

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.