connecting hose to low pressure system

Asked by harry22075 Jun 01, 2019 at 05:03 PM about the 2002 Saturn S-Series 4 Dr SL1 Sedan

Question type: General

readng high when connecting hose to low pressure system on vehicle air blowing out instead of sucking in refrigerant.

2 Answers

Check compressor to observe it running. Sounds like it is off (low pressure cutout switch). If it is running, check high pressure. If it is below expected you have broken valves in compressor.

44,020

Make sure you are actually connected to the low pressure side. With the compressor running, pressure should drop on the low side enough to draw is refrigerant vapor from the canister held upright. You can also warm the can carefully with a hair dryer to push refrigerant into system with engine off. Then run the A/C to read the high side pressure. A completely empty system will take about two 14 ounce cans. Wear safety glasses.

Your Answer:

CarGurus Experts

  • #1
    Alex Nazarian
    Reputation
    2,650
  • #2
    Paul Martin
    Reputation
    1,980
  • #3
    helpmeplease
    Reputation
    1,460
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.