Asked by Tamiskadsem Nov 11, 2019 at 04:37 PM about the 2007 Buick Lucerne V6 CXL FWD
Question type: Maintenance & Repair
Where is it located and how to make it blow warm
air not cold
lincolnscott49 answered 5 years ago
It may be the blend door actuator and you may be able to get to it by removing the glove box . Other wise you may have to remove the dash as if replacing the heater core and it is not a small job.
Where is it located and how to make it blow warm air not cold
2007 Buick Lucerne V6 CXL FWD
-
Maintenance & Repair
mode door actuator control fuse location
2010 Buick Lucerne
-
Maintenance & Repair
I pulled my glove box to get to the actuator. Upon visual inspection and adjusting the temperature I watched the actuator turn and the temp go up but air flow position never change from vents to def...
2000 Buick LeSabre Limited Sedan FWD
-
Maintenance & Repair
I get plenty of heat on the driver's side. There is no heart on the passenger side. I think the door blend actuator motor bad. When I go to auto parts stores, they only have drivers side or left ...
2003 Buick Rendezvous CX FWD
-
Maintenance & Repair
About 2 1/2 years ago I bought it used previously owned by my neighbor who said it was really good car w/ no problems. I soon noticed that RR door lock would sometimes not go down far enough to lock...
2009 Buick Lucerne CXL1 FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.