93 s10 blazer 4.3 v6

Asked by Briar Jul 30, 2020 at 10:04 AM about the 1993 Chevrolet Blazer 2-Door 4WD

Question type: Maintenance & Repair

Left me stranded 45 miles from home on a
highway doing 60. I've replaced coil cap rotor and
icm. I've tested it all and it shows power on my
voltage meter. It has power going to plugs but
wont start

1 Answer
157,855

James answered 4 years ago

Spray a little starting fluid down the throttle body and see if it'll run on that for a few seconds. If it will the fuel pump is my first suspect. If it won't run on the starting fluid run a compression test. If all cylinders test very low or zero it's jumped timing. Hope that helps! Jim

Mark helpful

Your Answer:

Related Questions

  • 93 s10 blazer 4.3 v6 1 Answer

    Left me stranded 45 miles from home on a highway doing 60. I've replaced coil cap rotor and icm. I've tested it all and it shows power on my voltage meter. It has power going to plugs but wont sta...

    1993 Chevrolet Blazer 2-Door 4WD

    -

    Maintenance & Repair

  • Sputtering Backfire - Chevy S10 With A Blazer 4.3 V6 Engine 10 Answers

    Hi guys, I have a 1994 Chevy S10 that has a 2002 Blazer 4.3 V6 vortex Engine in it. This morning on the way to work as I was going up an on-ramp (uphill) to get on the highway, the truck began to sp...

    2002 Chevrolet Blazer LS 2-Door RWD

    -

    Maintenance & Repair

  • 93 4.3 vortex s10 Blazer 11 Answers

    Got this did plugs and wires cap and button and retimed it because when I got it the timing was 180 out replaced the maf sensor and it ran and idled fine for about 15 min shut it off tightened the ...

    1993 Chevrolet Blazer 2-Door 4WD

    -

    Maintenance & Repair

  • 93 S10 Blazer starter drag / no start 2 Answers

    I recently squired a 93 S10 Blazer 4x4 4.3 CFI. It had sat for a long while prior to my ownership, hit it had been starting and running well. Last week pull into the driveway after work, and been t...

    1993 Chevrolet Blazer 2-Door 4WD

    -

    Maintenance & Repair

  • 95 s10 blazer 4.3 vortec vin w rough idle 1 Answer

    I'm still working on my 95 s10 blazer 4.3 vortec vin 4 it is idling rough & fouling plugs with black Sutt but is will rib up acts like the mass air flow sensor but don't have one I changed the o2...

    1995 Chevrolet Blazer LS 4-Door RWD

    -

    Maintenance & Repair

Shortcuts

Search Chevrolet Blazer Questions

CarGurus Experts

  • #1
    Andrew Olsen
    Reputation
    4,270
  • #2
    Rowefast
    Reputation
    3,570
  • #3
    yetilikesbeer
    Reputation
    2,420
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Jeep Grand Cherokee
113 Great Deals out of 3,142 listings starting at $3,995
Used Ford Explorer
78 Great Deals out of 2,100 listings starting at $3,995
Used Chevrolet Camaro
14 Great Deals out of 282 listings starting at $5,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.