i replaced the head gasks and intake manifold gasks on my 1993 350 Blazer and cannot get it to start now, i am getting fire and fuel. was starting fine and running but producing white smoke from exaust before gaskts replacement

Asked by blazer1993 Feb 21, 2017 at 12:31 AM about the 1993 Chevrolet Blazer Sport 2-Door 4WD

Question type: Maintenance & Repair

F_O_R answered 7 years ago

Check the ignition timing.

Mark helpful

35,335

lrodri911 answered 7 years ago

Timing is off. This engine can throw u off cause timing mark ligns up when timing is 180 degrees off. Make sure the mark is at TDC and #1 piston is up.

Mark helpful

35,335

lrodri911 answered 7 years ago

If timing is ok, do a compression test

Mark helpful

blazer1993 answered 7 years ago

I've been @ TDC W/ #1 up the whole time. this is only the 6th time i have redone head &intk gaskts i am at a lose what am i missing???

Mark helpful

59,755

enginecreator answered 7 years ago

Turn the engine over until the #1 piston comes up again.

Mark helpful

Your Answer:

i replaced the head gasks and intake manifold gasks on my 1993 350 Blazer and cannot get it to start now, i am getting fire and fuel. was starting fine and running but producing white smoke from exaust before gaskts replacement 5 Answers

1993 Chevrolet Blazer Sport 2-Door 4WD

-

Maintenance & Repair
My 2002 Chevy Blazer is not starting, Sounds like it is fuel starved. Just filled the tank and got home fine next day it doesnt start. It turns over for a second and then wont stay on on. if i keep trying it sounds more like it isnt getting fuel. I am thinking since I let the tank get low to check m,y milage I may have picked up some gunk in the tank and cloged the line somewhere. Any suggestions on how to go about diagnosing and fixing this? 5 Answers

My 2002 Chevy Blazer is not starting, Sounds like it is fuel starved. Just filled the tank and got home fine next day it doesn't start. It turns over for a second and then wont stay on on. if i keep...

2002 Chevrolet Blazer LS 4-Door RWD

-

Maintenance & Repair
my car was running fine, went into the store and when I came out the car would turn over but wouldn't start. could it be the fuel filter rather than the fuel pump? I checked the relay and its not that 1 Answer

As I said it was fine and now it will turn over but wont start. I checked the relay and that is ok. Please help, iam at a loss and really need my car.

2004 Chevrolet Blazer LS 4-Door 4WD

-

Maintenance & Repair
1999 Chevrolet Blazer 4.3L V6 Replaced CPI, fuel pump, fuel filter and fuel hoses but now the vehicle will not start. No gas to cpi unit. Do I need to bleed the system? 1 Answer

Replaced CPI, fuel filter, fuel pump, and fuel hoses. Unit will not start. Doesn't appearing to be getting fuel to cpi unit. Do I need to bleed the fuel system?

1999 Chevrolet Blazer

-

Maintenance & Repair
My blazer was running fine, went in the store and when I came out it would turn over but wouldnt start. I checked the relay and that is fine. Could it be the fuel filter rather than the fuel pump.HELP! 1 Answer

Car was fine, came out of store would turn over but not start. Could it be the fuel filter other than the fuel pump?

2004 Chevrolet Blazer LS 4-Door 4WD

-

Maintenance & Repair

Looking for a Used Blazer in your area?

CarGurus has 869 nationwide Blazer listings starting at $19,499.

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

i replaced the head gasks and intake manifold gasks on my 1993 350 Blazer and cannot get it to start now, i am getting fire and fuel. was starting fine and running but producing white smoke from exaust before gaskts replacement

5 Answers

Your Answer:

Looking for a Used Blazer in your area?

Shortcuts

Search Chevrolet Blazer Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

i replaced the head gasks and intake manifold gasks on my 1993 350 Blazer and cannot get it to start now, i am getting fire and fuel. was starting fine and running but producing white smoke from exaust before gaskts replacement

5 Answers

Your Answer:

Related Questions