My 1990 buick century custom starts but when you hit the brakes or try to put in gear shuts the car off why?

Asked by Lil_Dobey Jan 12, 2017 at 04:46 PM about the 1990 Buick Century Custom Sedan FWD

Question type: Maintenance & Repair

I just changed the spark plugs cause it was runnin
real bad found all 6 had broken porcelain, changed
wires, plugs, coil packs, new alternator. But now i
start it up its still running like crap at idle, revs
good, but stalls when i open the car door, or put my
foot on the brake, or try to put it in gear just shuts
right down with a check engine light and not
flashing any codes.

19,575

Jason answered 7 years ago

how is the fuel pressure? change the fuel filter and see if u get better idle. also rough idle can be from a miss fire. did u change the module under the coil packs?

Mark helpful

noyestoni answered 3 years ago

Might be your distributor

Mark helpful

Your Answer:

My 1990 buick century custom starts but when you hit the brakes or try to put in gear shuts the car off why? 2 Answers

I just changed the spark plugs cause it was runnin real bad found all 6 had broken porcelain, changed wires, plugs, coil packs, new alternator. But now i start it up its still running like crap at ...

1990 Buick Century Custom Sedan FWD

-

Maintenance & Repair
1995 Buick Century dies when I put brakes on, why? 3 Answers

My car starts, idles and runs fine until you put the brake on, idles down and just dies. What could be the cause?

1995 Buick Century

-

Maintenance & Repair
Buick Century 2000 starts no problem, but once i put the car in drive it won't move, and i hear a weird noise when i press on the gas. What can it be? 11 Answers

I was on the freeway from a long trip and the car suddenly i was giving the car gas and it and sounded and felt like i was in neutral. The car turns on but won't drive. Is it the transmission? If it ...

2000 Buick Century

-

Maintenance & Repair
i own a 2000 buick century custom. a couple months ago i had oil in my coolant/antifreeze so i had emptied it out cleaned and had put it back. well since that day my car wont start and now pops the IGN 0: cluster, pcm,& bcm 10a fuse. i have replaced the ignition switch, fixed the ignition column, flipped the starter, checked the fuse box yet it still keeps popping.i will be tracing wires to look for a short or grounded wires. any suggestions on what to do? 6 Answers

i own a 2000 buick century custom. a couple months ago i had oil in my coolant/antifreeze so i had emptied it out cleaned and had put it back. well since that day my car wont start and now pops the ...

2000 Buick Century Custom Sedan FWD

-

Maintenance & Repair
i have 2000 buick century custom, it started overheating when sitting at stop lights or going slow as soon as i moved it went back down, also there was no heat in the car, i loosed radiator cap 2 Answers

There was never any steam coming out from under the hood and when i moved the temp would go back down, also there was no heat in the car, i added antifreeze/water mix it still did it, then i loosene...

2000 Buick Century Custom Sedan FWD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.