You have to remove the headlamp from the car. Unscrew the two large thumbscrews under the hood. Pull the whole assembly forward. Remove the low beam connector. Replace the bulb, being very careful not to touch it. Reassemble the headlamp back into the car and install the two thumbscrews.
1998 Buick Park Avenue FWD
-
Maintenance & Repair
This car has been making two very worrying sounds... 1. At aprox. 1700RPM, the engine begins to make this "Hum" / "Growling" sound. Usually starts doing it right before shifting. [My rpm goes to...
1998 Buick Park Avenue Ultra FWD
-
Maintenance & Repair
I'm trying to figure out what could be wrong with my buick park ave. When I got it from my mother I had to jump start it to get it to start and once it finally started it ran good started on the fi...
1998 Buick Park Avenue FWD
-
Maintenance & Repair
what does one use to scan an obd 1 ? 94 buick. does it have an internal code reader like caddy ? if not will someone give me an answer . have an ob 2 scan but wont read. cant seem to find MALE obd...
1994 Buick Park Avenue Ultra FWD
-
Maintenance & Repair
every thing else work but low beams. for a while they were working most the time then just got worse till not work at all
1991 Buick Park Avenue FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.