Just had new heads put on my 99 chevy k1500 put in new distributor and distributors button new new plugs had timimg set runs good at first and than it will shake alittle and when you go up a hil it

Just had new heads put on my 99 chevy k1500 put in new distributor and distributors button new new plugs had timimg set runs good at first and than it will shake alittle and when you go up a hil it 2 Answers

My 89 chevy k1500 350 TBI will die after it runs for a bit and warms up then when u wait a couple minutes itll fire back up. any help? has new fuel filer, plugs and wires, cap and rotor, and new starter. 6 Answers

My 89 chevy k1500 350 TBI will die after it runs for a bit and warms up then when u wait a couple minutes itll fire back up. any help? has new fuel filer, plugs and wires, cap and rotor, and new sta...

I have a 1998 Chevy Silverado 1500 and I just put a brand new fuel pump in it and a New fuel filter. When I try to,stat it, it will not stat unless I poor gas in the tb and it will idle but when u giv 4 Answers

It gas it want to spit and spudder and,when it,get hot and u,try to put it,in drive it will just die and want start back up please help me to figure it out

I put new coils new plugs and wires. Not getting any fire 1 Answer

I have a 1992 chevy cheyenne 4.3 1500...i put new everthing new coils new plugs and wires new distributor new timing chain everything new and im not getting fire

so the other day i moved my 1997 chevy k1500 in my driveway and put my plow on then let it run for a while. I came bacj to it about 30 mins later and it was dead. I tried to crank it but got nothing. after going over everything replacing coil icm ecm crank sensor cam sensor plugs wires complete distributer from cap to oil pump . I have spark but when it it reaches distributer i get no spark to wires. Any ideas? I have never seen this before, im at a loss, please help!! 7 Answers

so the other day i moved my 1997 chevy k1500 in my driveway and put my plow on then let it run for a while. I came bacj to it about 30 mins later and it was dead. I tried to crank it but got nothing...