What can be the problem? 1993 Chevorlet Cheynne 1500 left signal wont work?
Asked by Guru81VQ May 02, 2017 at 08:56 PM about the 1993 Chevrolet C/K 1500 Cheyenne RWD
Question type: Maintenance & Repair
My turn signal works fine on the right side but when i set to the left it just clicks
rapidly and doesn't show any light.(no dash board arrow light or front/rear
signal lights) Iv tried changing the bulbs and i got the same results.
If anyone can help i would greatly appreciate it.
5 Answers
The problem is on the left side, try moving the bulb around in the socket while the turn signal is on to make contact.
Thanks @Rowefast for responding, Greatly Appreciated! After trouble shooting and a bit of research. I found out the problem is coming from my signal/wiper switch. The switch only works when i hold it in place half of the way to being on. Not sure of what the mechanics is inside. Does anyone know of what i may need to repair internally? do i need to fix the entire unit or is it a simple one piece fix? Thank you.... ....BTW if anyone is trouble shooting for a similar issue check: Circuit, Harness wire, signal flasher, bulbs or signal switch Good luck
You will have to take the steering wheel off and get down to the switch. You may get lucky and be able to do something for repair. Otherwise this is what you will be replacing, check it out on this sight... https://www.carid.com/1993-chevy-ck-pickup-electrical-parts/acdelco-gm-original-equipment-turn-signal-switch-442794068.html