I have a 1991 chev pickup truck k1500 when I start it its leak on the transmission on front and back

I have a 1991 chev pickup truck k1500 when I start it its leak on the transmission on front and back 1 Answer

I have a k1500 chevy pickup with a 350 motor It will not start all the time and shuts off when coming to a stop sometimes. 1 Answer

There is no ground single coming from the ecm to the injectors. I have replaced the ecm and throttle position, air idle, and map sensors. I also checked the ground wires and cleaned the conections.

I need help bad. My truck us a Chevy 1500 1995 and if I drive about 30 miles or so and hit a red light and go to hit the gas. I'll have the peddle to the floor and it will start off slow then out of no where kick in and speed up. And if I'm going down the high way and the cruise control is on and I'm going up a hill it will do that. Throttle slow then kick in and speed up. Also when I go to slow down pulling in some where the truck sounds like its about to shut off then comes back to normal. What wrong with it? 11 Answers

Ppl say it is my throttle body or my filter on my fuel pump or its I have no back pressure and my o2 senser is messed up since its straight pipe no cat converter. What is it.

so the other day i moved my 1997 chevy k1500 in my driveway and put my plow on then let it run for a while. I came bacj to it about 30 mins later and it was dead. I tried to crank it but got nothing. after going over everything replacing coil icm ecm crank sensor cam sensor plugs wires complete distributer from cap to oil pump . I have spark but when it it reaches distributer i get no spark to wires. Any ideas? I have never seen this before, im at a loss, please help!! 7 Answers

so the other day i moved my 1997 chevy k1500 in my driveway and put my plow on then let it run for a while. I came bacj to it about 30 mins later and it was dead. I tried to crank it but got nothing...

my chevy 1998 k1500 grinds while in 4wheel drive when i put a strain on it 1 Answer

when my truck locks in to fwd its fine untill i put a minimal strain on it then i hear a grinding noise and it seems like it comes out 4wd.