the distributor base on my 86 fiero is loose

5

Asked by Fiero93 May 12, 2015 at 09:45 PM about the 1986 Pontiac Fiero Sport

Question type: Maintenance & Repair

the whole distributor and cap are fine, but the base is loose and causes the cap to jiggle
while the engine is on therefore makes the engine misfire. any way to tighten it? i cant
find any way to fasten it or bolt the base down.

1 Answer
210

Stan answered 8 years ago

if the base clamp (see previous post) is tight, you might want to take it off and see if the shaft inside the dist is bent which will look like the cap part is wobbleing. you can take the cap off and turn the shaft by hand once you remove it and observe if it looks like it has been bent inside thetube by observing the rotor end of it. look close and if you see loose screws, tighten those dudes down under the cap... see if that helps any.

Mark helpful

Your Answer:

Related Questions

Shortcuts

Search Pontiac Fiero Questions

CarGurus Experts

  • #1
    THORNY68
    Reputation
    1,100
  • #2
    Steve Neyens
    Reputation
    610
  • #3
    Andrew Welsh
    Reputation
    520
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Pontiac Firebird
13 listings
Used Ford Mustang
57 Great Deals out of 1,352 listings starting at $4,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.