I have a 1998 acura intregra that wont start without jumper cables but when we disconnect the cables car stalls out. Just replaced alternator, and the wiring harness. Any ideas what it could be.

Asked by Candice Nov 05, 2014 at 09:51 AM about the 1998 Acura Integra LS Sedan FWD

Question type: Maintenance & Repair

Candice answered 10 years ago

No we disconnected the jumping cables not the battery cables.

Mark helpful

98teggylove answered 10 years ago

im havin the same problem there trying to say that the wiring harness is bad but it worked jus fine b4 i replaced the battery n alternator wtf man what do i do

1 people found this helpful.

Mark helpful

98teggylove answered 10 years ago

my car is a 98 teggy ls jus bolt on for now got coilovers n wheels n tires on the way n 15x8 fit alright as long as im not to low?

Mark helpful

Your Answer:

I have a 1998 acura intregra that wont start without jumper cables but when we disconnect the cables car stalls out. Just replaced alternator, and the wiring harness. Any ideas what it could be. 3 Answers

1998 Acura Integra LS Sedan FWD

-

Maintenance & Repair
just did the timing to my acura rs and now it wont start what should i be looking for 4 Answers

replaced cap and rotor, ignition coil and ignition control modual (wich was the initial problem) got the car running but it was running really rough because both cams were stuck open, i did the timi...

1993 Acura Integra RS Coupe FWD

-

Maintenance & Repair
my 1997 acura integra gsr wont start after It gets warm I have got new plugs and wires and it has spark so what else could it be? 2 Answers

it will start and I can drive it but only once a day when I shut it off it wont start again it still has spark just wont turn over.

1997 Acura Integra GS-R Coupe FWD

-

Maintenance & Repair
I have an automatic transmission and sometimes when I try to put in another gear from "park", it is locked and I have to put the key in the keyhole next to the gearshift to "unlock" it. Any ideas of what may be failing or wrong? 6 Answers

This problem just started happening this week and it figures the inspection is due this month. It locks in gear (park) and I can't get it out of park without "unlocking" it.

1998 Acura Integra LS Coupe FWD

-

Maintenance & Repair
I HAVE A 1992 ACURA INTEGRA THAT CRANKS WELL BUT NO FLOW TO THE PLUGS. A TOTALLY BRAND NEW IGNITION SET AND NEW MAIN RELAY STILLS CRANKING BUT NO SPARK.. ISSUE STARTED 30 DAYS AGO BUT WAS INTERMITENT 1 Answer

I HAVE A 1992 ACURA INTEGRA THAT CRANKS WELL BUT NO FLOW TO THE PLUGS. A TOTALLY BRAND NEW IGNITION SET AND NEW MAIN RELAY WERE INSTALL BUT STILLS CRANKING BUT NO SPARK.. ISSUE STARTED 30 DAYS AGO ...

1992 Acura Integra LS Coupe FWD

-

Maintenance & Repair

Looking for a Used Integra in your area?

CarGurus has 170 nationwide Integra listings starting at $30,990.

Used Honda Civic

175 Great Deals out of 3,756 listings starting at $3,495

Used Honda Accord

41 Great Deals out of 909 listings starting at $1,599

Used BMW 3 Series

71 Great Deals out of 1,170 listings starting at $1,995

Used Toyota Camry

48 Great Deals out of 996 listings starting at $2,212

Used Ford Mustang

64 Great Deals out of 1,285 listings starting at $4,995

Used Toyota Supra

63 listings starting at $51,977

Used BMW M3

9 Great Deals out of 87 listings starting at $15,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

I have a 1998 acura intregra that wont start without jumper cables but when we disconnect the cables car stalls out. Just replaced alternator, and the wiring harness. Any ideas what it could be.

3 Answers

Your Answer:

Looking for a Used Integra in your area?

Shortcuts

Search Acura Integra Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

I have a 1998 acura intregra that wont start without jumper cables but when we disconnect the cables car stalls out. Just replaced alternator, and the wiring harness. Any ideas what it could be.

3 Answers

Your Answer:

Related Questions