2007 impala code say after changing cranksensor harness ciircuit 1 volt low
Asked by Guru96RW1V Nov 21, 2022 at 06:24 PM about the 2007 Chevrolet Impala 3.5L LT FWD
Question type: Maintenance & Repair
car start then stops immediately no gas pedal control to keep it going
3 Answers
Recheck your work first. Then you need to test both the power in and power out, now it could be just a bad sensor but if reference voltage is already low going in then you have bigger problems.
1 people found this helpful.
Guru96RW1V answered about a year ago
thank you i am going to change my gas pedal today i have no control of thr pedal to rev up the gas
If you have a short to ground of the reference voltage it would cancel out any throttle body control. I would test the reference voltage at the TPS first. Are you getting any other codes?