2003 Saturn LW300 ECM
10

Asked by Greasymama4 Jun 24, 2016 at 05:56 PM about the 2003 Saturn L300 Base

Question type: Maintenance & Repair

Changed the motor in my car. I put my original ECM on the new motor due to
the one that was on it wouldn't start my car. When I put the ECM on it from my
original motor, she will start and run cold, after heated up and shut off it'll start
but when you push the gas there's a hesitation and the rev takes a few seconds
to increase but will only go half rev......any suggestions. I've checked all
connections, fuel pressure, exhaust, everything except flash the ECM. Is that
what I need to do?

3 Answers
42,385

Auto_Centric answered 8 years ago

Forget flashing the computer, unless you have the electronic gear, and what would you flash it too? The correct PCM is the one designed for the engine, fuel map and timing map, If you changed to different year engine it might have a series change? I don't know Saturns base,should be a 2.2 liter? but engine management is all the same, Next is the vehicle harness and cluster mileage and PCM are all coded together.. So buy the correct PCM for the year engine you installed and change the rest of the car so it runs with the factory engineered fuel and ignition timing and all maps

Mark helpful

Your Answer:

Related Questions

L300

Looking for a Used L300 in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

Shortcuts

Search Saturn L300 Questions

CarGurus Experts

  • #1
    GuruTS23S
    Reputation
    700
  • #2
    Racer_X
    Reputation
    490
  • #3
    dandyoun
    Reputation
    460
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.