If there is no existing hole you will have to drill one.
I would like to know where the wires from the license plate lights actually go into the trunk as they are existing lights. So they are factory wired. I know they run behind the bumper fascia and I believe to the passenger side, I just can't see where they enter the vehicle.
2008 Chrysler Sebring Touring Sedan FWD
-
Car Customization
Trying to hook up an amp and subs. Nothing too complicated, but I don't know how to get the cable through from the battery into the car! Any help would be appreciated. Also, can I just hook the amp to...
2008 Chrysler Sebring
-
Car Customization
I have a 2002 Chrysler Sebring and am wondering if I can replace the bumper to the 04-06 bumper if I change the headlights also or would it be a lot more involved that that? I know the hood can be swi...
2002 Chrysler Sebring LX Convertible FWD
-
Car Customization
I have the motor ready to do it but idk of I should.
2002 Chrysler Sebring LXi Coupe FWD
-
Car Customization
I was wondering would 18x8 or 18x8.5 fit on my crysler sebring lxi convertable without raising it and if so how high would i have to raise it
2002 Chrysler Sebring LXi Convertible FWD
-
Car Customization
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.