trying to troubleshoot ignition system.
Put a 2006 motor into a 2008 Buick Lucerne and the whole ignition system has
no power and not communicating
Asked by Guru9BQ6HP Jun 23, 2021 at 10:13 PM about the 2008 Buick Lucerne CXS FWD
Question type: Maintenance & Repair
Put a 2006 motor into a 2008 Buick Lucerne and the whole ignition system has
no power and not communicating
beatupchevy answered 3 years ago
Did you use the computer from the 06 ? If you did the ignition transponder won't communicate with the computer , If you didn't the 08 computer may not respond . Things can't be swapped around easily with all the tech. on cars .
Put a 2006 motor into a 2008 Buick Lucerne and the whole ignition system has no power and not communicating
2008 Buick Lucerne CXS FWD
-
Maintenance & Repair
08 Buick ucerne 3.8, I hav e n o action on the fuel and shift/gear indicato, also no crank using the key/ignition, ran a bypass (now cranks). Is this a faulty internal mode switch or something else?
2008 Buick Lucerne
-
Maintenance & Repair
seat is jamed and wont slide but about 4 inches on one side when trying to adjust
2010 Buick Lucerne
-
Maintenance & Repair
My key is stuck in ignition and would start and run fine but then I unscrewed the plastic piece under the steering wheel to see if there was a key release and now it won't start or do anything whe...
2007 Buick Lucerne V6 CXL FWD
-
Maintenance & Repair
Afraid to take car out as it might not start on 2nd or 3rd try. Why does it start sometimes, and other times I get nothing. not even a sound when I turn the key?
2007 Buick Lucerne V6 CXL FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.