I am trying to remove my crank shaft pulley bolt but both the pulley and bolt keep spinning and I am moving the car. This is on a 2008 Mustang GT. Is this normal?

I am trying to remove my crank shaft pulley bolt but both the pulley and bolt keep spinning and I am moving the car. This is on a 2008 Mustang GT. Is this normal? 1 Answer

The six-groove part of my crank pulley is missing. 8 Answers

I left work the other day and heard a clunk and the belt started to squeal very loudly! I thought it was my power steering pump going out but, when I looked, I noticed the six-grooved part on the mai...

How to remove a stuck pulley puller. 2 Answers

I was trying to remove my power steering pulley (that was a success) now the puller for the pulley is stuck how do you remove this?

my 1988 mustang gt convertible usually runs great but sometimes it idles up and down and will even die. the problem stops when i accelerate but will continue at cruising speed. sometimes it does not happen for days, then when it happens it can last for a few seconds up to a day. i have replaced the cap, rotor, plugs, wires, fuel filter and egr valve. it feels like a vacuum issue, but i do not think a vacuum issue would come and go like this. i am lost! please help 3 Answers

my 1988 mustang gt convertible usually runs great but sometimes it idles up and down and will even die. the problem stops when i accelerate but will continue at cruising speed. sometimes it does not...

I have a 1989 mustang 5.0, the other day i accidentally left my headlights on and killed the battery. After jump starting, car now is sputtering and wants to stall out some times. what could this be? 1 Answer

also, the volt guage is showing low volts. could the battery be bad? thank you for any responces.