Looking for the location of the remote anit-theft module.
bought this vehicle used and need the factory setting so I can change the door code.
I've found door codes printed on the remote module in various locations, 1) inside the driver door & 2) tucked up under dash on passenger side. They can be hard to see, it helps to fish a digital camera with flash up in there to snap a pic of it, rather than contorting your body around. Try an Explorer forum for more specific help on locations of modules.
bought this vehicle used and need the factory setting so I can change the door code.
2008 Ford Explorer XLT
-
Maintenance & Repair
Will start at times, but usually will not after driving and the engine becomes warm.
2002 Ford Explorer XLT
-
Maintenance & Repair
I need to locate the low pressure ac port on a 2010 ford explorer 4.0L V6 engine. Also need to locate the low pressure cycling switch and how to remove it and attach a jumper wire.
2010 Ford Explorer Eddie Bauer
-
Maintenance & Repair
I have a 1998 Ford Explorer that blows COOL air in the rear. The rear control cluster works fine. But when it comes to the front control cluster, THERE IS NO HEAT, & NO BLOWER. I have filled the rese...
1998 Ford Explorer 2 Dr Sport SUV
-
Maintenance & Repair
Hello, My 2013 Explorer has a clunk in the right rear when i hit a bump at low speeds. After inspection everything looks tight. As well as I have a clicking sound when i apply the brakes after backi...
2013 Ford Explorer XLT 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.