When receiving SERVICE RSC NOW message from explorer 2008; which spare parts are subject of replacement
Asked by explorer2008 Jun 21, 2015 at 06:20 AM about the 2008 Ford Explorer XLT 4WD
Question type: Maintenance & Repair
When receiving SERVICE RSC NOW message from explorer 2008; which spare parts are
subject of replacement
9 Answers
It makes the idol goes up
DavidSandberg1977 answered 8 years ago
Would this keep me from being able to turn car over now. Cause I shut car off n now won't come on.
My RSC came on on my gauge board and also my ford van can't start? What to do
Will it hurt to drive the truit or will it cause more damage also it make a noise ding ding
I had this message. My 2008 ford explorer front right side bearing had worn out. It is connected to ABS. When I replaced the bearing hub assembly, the message along with ABS is gone.
Replace the Restraint Control Module! That will solve your problem!!!!!!
Guru99CML3 answered 4 years ago
before spending any money just try to do this 1.Check the brake signs it may also effect 2.Check the hand brake may be you forgot to lift it 3.Hold the middle button (stability control) on the dash board for few minutes (which will not help) but try 4.Even if the brake fluid sensor is not working it will show RSC so check if you are getting this on dash board 5.Last remove the ECM ,PCM fuse and remove and fix again. 6.If RSC is coming along with ABS sign then you need to change the ABS bearings, if not the its not related to ABS. 7. This happens when the sensors m does not report to the system 8. Remove the Battery connection for 10 minutes if all this does not work then go for computer testing
Guru99CML3 answered 3 years ago
Service RSC now is common issue reported in FORD Explorer . for this make computer test and fid the codes if the OBD cant read the codes for ABS Module or shows any code related to ABS module , Then you need to Replace the ABS Module . Over All at final you need to Replace The ABS Module if you are getting the Indication Service RSC now . So after replacing you need to program it again then only the BEEP sound will close .