2008 chrysler300 Put the plastic key in the ignition and turn to start. There is a delay before the starter engages

2008 chrysler300 Put the plastic key in the ignition and turn to start. There is a delay before the starter engages 4 Answers

I HAVE A 2008 CHRYSLER 300 my problem is when I go to turn on the car I turn the key and it don't start right away I have to hold the key a couple of seconds for it to turn on then I let the key go. 2 Answers

Sometimes I turn the key, it turns on quick ... Sometimes I turn the key ,hold it on a lil bit , and then let go,a couple seconds later it turns on what might the problem be ...is it a fuse , a s...

I have a 2007 Chrysler 300. One day the car is running fine. I put the key in the igntion and turn it and the radio and dash board lights go on. but the engine wont go on. I use my Autostart and the car starts right up. Can anyone pleae tell me what it could be . I thought it could be the Igntion Switch pin. 2 Answers

I have a 2007Chrysler 300. One day my car is fine. I get in my car I put the key in the igntion turn it on and the only thing that worked was the radio and the dash board lights.It would not start. ...

have a Chrysler 300 2006 2.7 car ran great the moment we did an oil change things started to happen. took it to shop they changed crank shaft. plus changed sensor, new battery, changed eco had it programmed, starter went out so we changed that I also checked fuses and when all said and done we went to start it and all you hear is think sound. the red lighting bolt light comes on and stays on the moment u put key in start potion but it won't start 3 Answers

what could be the problem

2005 - water in the trunk and now car is dead. Is there a drain plug? 2 Answers

2005 - water in the trunk and now car is dead. Is there a drain plug?