spindle and knuckle assemblies interchangeable between an '09 and an '08

Asked by Gcogswell Feb 24, 2020 at 04:52 PM about the 2008 Chrysler PT Cruiser Convertible FWD

Question type: Maintenance & Repair

I am trying to get an a replacement driver front spindle and knuckle assembly
for my '08 pt cruiser and I have my eye on an '09 for parts. are they
interchangeable?

F_O_R answered 4 years ago

Look up the part at a car parts site and see if it is listed for both years.

1 people found this helpful.

Mark helpful

22,255

Gary answered 4 years ago

Yes. 2002 - 2010 are the same according to rockauto.com.

Mark helpful

Your Answer:

spindle and knuckle assemblies interchangeable between an '09 and an '08 2 Answers

I am trying to get an a replacement driver front spindle and knuckle assembly for my '08 pt cruiser and I have my eye on an '09 for parts. are they interchangeable?

2008 Chrysler PT Cruiser Convertible FWD

-

Maintenance & Repair
I have an 2002 Pt and it keeps boiling coolant, had Chrysler repair system new water pump, new fan and thermostat and it goes on. They are unable to fix it, boils on long distances only now, help! 2 Answers

I am going bankrupt trying to keep this on the road, they have flushed radiator system twice, repaired cooling system at Chrysler. it now boils coolant on longer trips only. I have had fan assembly,...

2002 Chrysler PT Cruiser Wagon FWD

-

Maintenance & Repair
I have an 03 cruiser which has been over heating. Before i could repair the resevoir leakt i was driving and noticed a tick. Quickly the tick got stronger and faster until it died. The temp guage was 1 Answer

normal but when i shut it off and tried to start it again the temp guage shot through the roof. No milky oil, cranks fine, and has gas. Did i blow the 3rd motor in this car. Yup, within 3 months o...

2003 Chrysler PT Cruiser Wagon FWD

-

Maintenance & Repair
Vibration and noise 1 Answer

I have a 2007 pt cruiser with 178,000 miles the engine is loud not knocking or anything just loud and when I press my brakes my car vibrates really bad around the floorboard what could cause this

2007 Chrysler PT Cruiser Touring Wagon FWD

-

Maintenance & Repair
I'm looking into getting a used pt cruiser with 2.4 turbo. I'm concerned though because of the timing belt issues and fallout when they fail. Does the turbo engine have the same issues? And the turbo? 5 Answers

Is there a difference between 05-08 years? What is difference between interference and non? Which one does the 2.4t have? What about turbo or transmission problems? Would appreciate some feedback. T...

2006 Chrysler PT Cruiser GT Wagon FWD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.