All those numbers are much too low. Sounds like you have a worn out engine but it is possible the timing chain was installed incorrectly and is off a tooth or two. It is also possible the head gasket job was not done correctly. Was this done at a professional shop or is it a shade tree mechanic job?
I have a 2005 mini cooper i just picked up. Was told check engine light is on due to cylinder 3 misfire. Ive changed plugs, wires, coil pack. Drove fine for a min. Then car started riding rough. No...
2005 MINI Cooper Convertible
-
Maintenance & Repair
cylinder 4 compression is 70 All other cylinders between 90-95 The car misfiring after head gasket job Timing chain kit has been replaced
2008 MINI Cooper S
-
Maintenance & Repair
I have a 2009 Cooper S with about 114k. I bought it used and have had it for 6 months or so. This past week it started running rough with misfires. I had my buddy who is a car guy and builds his ...
2009 MINI Cooper S
-
Maintenance & Repair
Car has rough to very rough idle after engine temp is normal. Keeps throwing codes for cam position sensor and cylinder number 3 misfire. Replaced all spark plugs, ignition coils, and both cam posi...
2008 MINI Cooper Base
-
Maintenance & Repair
Checked oil and it was low. Added oil and it hasn't run right since. Spent $2400 on repairs and it still idles rough. Changed Water pump, cross tube, thermostat, VVT, valve cover, fuel cap, spark plug...
2010 MINI Cooper S
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.