my 2010 jeep wrangler rubicon has battery power but the power doesnt opperate new starter selinoid
I replaced starter switch and actuater pin as well as put a new starter and selinoid.
Asked by corybear69 Mar 12, 2017 at 04:07 PM about the 2010 Jeep Wrangler Rubicon 4WD
Question type: Maintenance & Repair
I replaced starter switch and actuater pin as well as put a new starter and selinoid.
May have a low battery, or the battery connections may need to be cleaned. Otherwise you should check that there is power going to the small terminal on the starter solenoid when someone is turning the key to the start position, while you are checking. Could be something else other than the solenoid.
I replaced starter switch and actuater pin as well as put a new starter and selinoid.
2010 Jeep Wrangler Rubicon 4WD
-
Maintenance & Repair
My 92' Jeep Wrangler has got no power going through it. I was going down the road about 45 mph, when it just died without a warning. After it happen i turned the key and it doesn't do anything. It w...
1995 Jeep Wrangler S
-
Maintenance & Repair
Has new starter & battery. Trying new starter relay now...any ideas if that doesn't work?
2001 Jeep Wrangler Sport
-
Maintenance & Repair
All other panels are working and lighted. The radio just quit!
2009 Jeep Wrangler
-
Maintenance & Repair
Hi my left back light is out and my left blinker blinks really fast. Is it just a light bulb fix or more in depth and how so? How can I tell the difference and is it easier to take just take to a ...
2010 Jeep Wrangler Sport 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.