Won't shift into drive or reverse
Asked by Trubluocguy Jan 16, 2015 at 05:01 PM about the 2006 BMW 7 Series 750Li RWD
Question type: Maintenance & Repair
When putting the vehicle into drive or reverse, it won't move. And automatic jumps back
into park.
14 Answers
Trubluocguy answered 9 years ago
You mention the clutch and the stick.mits an automatic. I would normally step on the brake, and then shift the lever to either drive or reverse.
In side valve body is seal need to change
trucktraylor123 answered 7 years ago
Change your fluid it is low or empty
I was on the highway doin about 80mph n my car stoped goin engine was still on I have a 1992 735il BMW
Same thing happened to my 2005 bmw 530i. Its stopped last week going into reverse and now it wont move when it go into drive
I have a 2006 750ii and I changed the battery out the car Now the will start but can't get it to shift in gears . Whats the problem ?
I have a 2006 750ii and I changed the battery out the car Now the will start but can't get it to shift in gears . Whats the problem ?h
Do you guys figure it out? I saw a YouTube video that said, when a new battery is replaced we need reprogram it pretty much? I haven’t tried it but will do hopefully tomorrow let me know if y’all found otherwise
I tried to reset my vehicle reset but it tells me reset not possible can you help me out
Start your car and rev the engine over 3K rpm and it will allow you to place it in gear.
My 2007 BMW 750li won’t shift into gear either. Looked at the fluid found that is was completely low. The Transmission fault moderately light is on. Filled up the fluid and still won’t allow me to shift into a gear. You can also tell that it won’t to shift, but something is holding it back from doing so and placing it right bk into park. Any help would be greatly appreciated! Thanks and God bless!
Marty Anselm answered 4 years ago
I don't have the answer but my 2007 bmw 750i is doing the same. I can't put it into gear. It keeps jumping back to park. I did a transmission service, filled it with fluid and everything. Please help me
Guru9TYPN3 answered 3 years ago
likely faulty igition coils. need to swap out all of majority of the coil at once
I have a 2008 BMW X5 and everytime I shift into drive or reverse it goes basic into park what is this. Issue ?