2011 ford escape
2011 escape wont start at time when turned to start position if you turn key hard to start position it starts at times if not you back key off and try again and it starts
I had this issue with my 2008 Ford Escape. The ignition switch was worn down so the ignition lock cylinder couldn't turn it where they join. The ignition switch is made of hard plastic so it eventually wears down after a while. The part is about 50 bucks from most part stores. I worked for AutoZone at the time, and replaced the part myself. I was quoted about 4-5 hundred to have a shop do it. Hope this helps!
I have a 2011 Ford Escape. When I move the vehicle from park there is a rather large jolt. We hooked the vehicle up to computer and received the following errors: Pressure Control Solenoid A Control...
2011 Ford Escape XLS FWD
-
Maintenance & Repair
2011 escape wont start at time when turned to start position if you turn key hard to start position it starts at times if not you back key off and try again and it starts
2011 Ford Escape XLS FWD
-
Maintenance & Repair
Can I just unplug the rear wiper instead of removing the fuse on my 2011 Ford Escape
2011 Ford Escape XLT FWD
-
Maintenance & Repair
My 2011 escape has been in the shop four times and still has the same air conditioning issue. After recharge it runs for a day then blows hot aor. High side pressure crazy and locks up system says ...
2011 Ford Escape
-
Maintenance & Repair
Our 2011 Ford Escape's AC isn't working properly. At first blower levels 1 and 2 were not working, the AC was working sometimes and not others, and then the fan was turning and running almost consta...
2011 Ford Escape Limited FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.