4wd transfer control module
Asked by Dispatier Apr 12, 2018 at 02:42 PM about the 2005 Ford Ranger 2 Dr Edge 4WD Extended Cab SB
Question type: Maintenance & Repair
My truck is stuck in 4wd low, which seems to be
not uncommon, and is attributed to the transfer
control module, however, when I opened up the
passenger kick plate to find the module, it isn't
there.. where else would it be located?
4 Answers
The problem is with the actuator, that is bolted to the transfer case,It's not a computer issue.
Dipsplater answered 6 years ago
My 2005 ranger has a new transfer case actuator motor but will still not engage 4x4 but will tell me it is 4x4 on the dash what should I do
Mine is a 2011 ford ranger. Its not on passenger side... Its behind the radio on the left. Take out 2 screws under radio and very small flat head screw driver and pry face and radio out. Disconnect a few plugs on the sides and should be able to pull radio out of way to get to the module.
Guru9YKSRK answered 3 years ago
Saying it is not a module issue is not necessarily correct. It's electronics, if the module is malfunctioning no telling how the transmission will respond. Troubleshooting without a schematic is precarious at best.
